Xiaomi MDE2 Mi 5x/A1 After Flash Restart Problem Solve blinking Dead Recover ALL Problem Fix Firmware 100% Tested

     

Xiaomi MDE2 Mi 5x  After Flash Restart Problem Solve blinking Dead Recover ALL Problem Fix Firmware 100% Tested BY ME

     

                           AFTER FLASH AUTO RESTART PROBLEM FIX 100%
               
                       AFTER FLASH BLANK LCD PROBLEM FIX 100%
 
          <......AFTER FLASH BLANK LCD PROBLEM FIX 100%

                      AFTER FLASH BLANK LCD PROBLEM FIX 100%  

                           AFTER FLASH IMEI BASEBAND REPAIR  FIX 100%

                                                                             
                                         



                                            
                            

Mi 5x/A1 restart problem solve

Flash with Mi Flash Tool Official Firmware

                                                                            

                                                                                       

                                   FLASH WITH ANY OTHER TOOLS OR DONGLES

                                            

                                                    

                         PAID ONLY FILE PRICE:- 100TK

                   CONTACT FOR PASSWORD:01719299597

1. Download unbrick patch which includes oxygen bootloader for MiFlash. Unpack downloaded archive in new folder.
2. Download and install latest MiFlash tool on your PC: MiFlashSetup_eng.msi
3. Remove the back panel on your phone and look for test points and disconnect the battery.
4. Connect USB cable to your phone. Do not connect to PC yet.
5. Connect the test-points (I assume that boots your device in EDL mode) and now connect your phone to PC. Go to “Device manager” and check if your device is found as “COM-port”, “Qualcomm HS-USB QDLoader 9008”).
6. Start MiFlash tool.
7. Press “select” and find previously unpacked “unbrick” archive.
8. Press “refresh” and COM port should be now displayed in the list.
9. Finally press the “flash” button to start installation process. Wait a few seconds for “flash done” and “success” messages to appear.
10. Disconnect your device from PC and connect the battery again. Turn off.
11. Now your device should be unbricked and you can boot without any problems.